Ostin kyseisen tukiaseman ja sen asensin.. mutta nyt power valo vilkkuu enkä mitenkää saa sitä toimimaan ja power vilkkuu vaa.. Mitä pitää tehdä. Ohjeissa lukee jotai wirmwaresta tai sellasesta mut tuskin se sitä monta tuntia päivittää tai mitää.. se vaa vilkuu :/ ja ennen sitä toisesta koneesta kortti löyti yhteyden tukiasemaan muttei nettiin. nyttei löydä edes tukiasemaankaan kun se power vilkkuu. Mitä teen?
linksys wrt54g
Make
1345
0Äänestä
Muut lukivat myös
Odottaa vastausta
Näihin keskusteluihin ei ole vielä vastattu. Ole ensimmäinen.
Vastaukset 1
Vanhimmat
Suoraan laitteen mukana tulleesta pdf-ohjeesta:
"The firmware upgrade failed, and/or the Power LED is flashing.
The upgrade could have failed for a number of reasons. Follow these steps to upgrade the firmware and/or
make the Power LED stop flashing:
• If the firmware upgrade failed, use the TFTP program (it was downloaded along with the firmware). Open
the pdf that was downloaded along with the firmware and TFTP program, and follow the pdf’s
instructions.
• Set a static IP address on the PC; refer to “Problem #2, I need to set a static IP address.” Use the following
IP address settings for the computer you are using:
IP Address: 192.168.1.50
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
• Perform the upgrade using the TFTP program or the Administration tab of the Router’s web-based utility."
Mukana tulleista ohjeista löytää kaiken tarvittavan tiedon tukiaseman asennukseen ja tarvittaviin asetuksiin. Ja netistä googlettamalla lisää. Firmwaret ei pomppaa automaattisesti sinne lootaan, vaan ne pitää ladata ja flashata. Yksi firmware-ohje:
http://homepage.ntlworld.com/linksysinfo/revival/