Miten saan CDRW-aseman HP 8200e:n toimimaan Zenwalk:ssa? K3b ja Gnomebaker eivät löydä koko asemaa. Dmesg kertoo ettei pysty lukemaan:
dmesg:
---------
csi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
Vendor: HP Model: CD-Writer 8200e Rev: 0001
Type: Direct-Access ANSI SCSI revision: 00
not responding...
sda : READ CAPACITY failed.
sda : status=1, message=00, host=0, driver=08
sd: Current: sense key=0x6
ASC=0x28 ASCQ=0x0
sda: test WP failed, assume Write Enabled
sda: assuming drive cache: write through
not responding...
sda : READ CAPACITY failed.
sda : status=1, message=00, host=0, driver=08
sd: Current: sense key=0x6
ASC=0x28 ASCQ=0x0
sda: test WP failed, assume Write Enabled
sda: assuming drive cache: write through
not responding...
sda : READ CAPACITY failed.
sda : status=1, message=00, host=0, driver=08
sd: Current: sense key=0x6
ASC=0x28 ASCQ=0x0
sda: test WP failed, assume Write Enabled
sda: assuming drive cache: write through
sda:end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
Buffer I/O error on device sda, logical block 0
unable to read partition table
sd 0:0:0:0: Attached scsi removable disk sda
usb-storage: device scan complete
sd 0:0:0:0: Attached scsi generic sg0 type 0
dmesg:
---------
csi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
Vendor: HP Model: CD-Writer 8200e Rev: 0001
Type: Direct-Access ANSI SCSI revision: 00
not responding...
sda : READ CAPACITY failed.
sda : status=1, message=00, host=0, driver=08
sd: Current: sense key=0x6
ASC=0x28 ASCQ=0x0
sda: test WP failed, assume Write Enabled
sda: assuming drive cache: write through
not responding...
sda : READ CAPACITY failed.
sda : status=1, message=00, host=0, driver=08
sd: Current: sense key=0x6
ASC=0x28 ASCQ=0x0
sda: test WP failed, assume Write Enabled
sda: assuming drive cache: write through
not responding...
sda : READ CAPACITY failed.
sda : status=1, message=00, host=0, driver=08
sd: Current: sense key=0x6
ASC=0x28 ASCQ=0x0
sda: test WP failed, assume Write Enabled
sda: assuming drive cache: write through
sda:end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
Buffer I/O error on device sda, logical block 0
unable to read partition table
sd 0:0:0:0: Attached scsi removable disk sda
usb-storage: device scan complete
sd 0:0:0:0: Attached scsi generic sg0 type 0
Vastaukset
Vanhimmat
Ei vielä vastauksia
Aloittaja odottaa vastauksia. Kerro oma näkemyksesi ensimmäisenä.