Nettyhteyden seurantaohjelmaa?

En nyt täysin tollasta tiedä, mutta koeta katsoa jos joku näistä vastaa vaatimuksia:

http://www.snapfiles.com/freeware/network/fwnetmoni.html

Itse olen käyttänyt CurrPorts nimistä ohjelmaa nettiliikenteen seuraamiseen, mutta se ei muistaakseni näytä kaistankäyttöä.

Pienellä Prio-lisäpalikalla tehtävienhallintaan http://climsy.com/djpc64k71b.jpg .

Et tarvitse mitään lisäohjelmia, Windows 7 sisältää tuollaisen toiminnon:
http://aijaa.com/006999165932.png

Ja komentokehotteessa netstat.

TCPVIEW on paras.

Sysinternalsin tcpview on graafinen ohjelma, mutta kyllä netstat avulla asiat selviävät myös. Voi kokeilla esim. netstat -ano tai netstat -abo


netstat [-a] [-b] [-e] [-n] [-o] [-p <Protocol>] [-r] [-s] [<interval>]

-a Displays all active TCP connections and the TCP and UDP ports on which the computer is listening.

-b Displays the executable involved in creating each connection or listening port. In some cases well-known executables host multiple independent components, and in these cases the sequence of components involved in creating the connection or listening port is displayed. In this case the executable name is in [] at the bottom, on top is the component it called, and so forth until TCP/IP was reached. Note that this option can be time-consuming and will fail unless you have sufficient permissions.

-e Displays Ethernet statistics, such as the number of bytes and packets sent and received. This parameter can be combined with -s.

-n Displays active TCP connections, however, addresses and port numbers are expressed numerically and no attempt is made to determine names.

-o Displays active TCP connections and includes the process ID (PID) for each connection. You can find the application based on the PID on the Processes tab in Windows Task Manager. This parameter can be combined with -a, -n, and -p.

-p <Protocol> Shows connections for the protocol specified by Protocol. In this case, the Protocol can be tcp, udp, tcpv6, or udpv6. If this parameter is used with -s to display statistics by protocol, Protocol can be tcp, udp, icmp, ip, tcpv6, udpv6, icmpv6, or ipv6.

-s Displays statistics by protocol. By default, statistics are shown for the TCP, UDP, ICMP, and IP protocols. If the IPv6 protocol is installed, statistics are shown for the TCP over IPv6, UDP over IPv6, ICMPv6, and IPv6 protocols. The -p parameter can be used to specify a set of protocols.

-r Displays the contents of the IP routing table. This is equivalent to the route print command.

<interval> Redisplays the selected information every interval seconds. Press CTRL C to stop the redisplay. If this parameter is omitted, this command prints the selected information only once.

/? Displays help at the command prompt.