Eli sain jokin aika sitten uuden koneen jossa on SEAGATE BARRACUDA 7200.10 320GB SATA kovo. Eräs tuttavani asensi koneen. Mutta asiaan... epäilen että kovo on asennettu idenä. Mistä näkee onko kovalevy asennettu sata II:na vai idenä? ja voiko sen asentaa sata II:ksi jälkikäteen? esim. laittamalla jotain ajureita.
SiSoftware Sandra herjaa kovosta tämmöstä: En ite tajuta tosta mitään...
Warning W3104 - Current transfer mode not optimal, i.e. not highest supported. This affects drive performance. If the controller is also capable of the highest supported transfer mode, there is no reason not to use it.
Fix: First check controller supported transfer modes. Then check the mode the driver for the controller/BIOS is set to use and modify; some default to a lower mode for compatibility. You may need to install newer drivers if the current drivers do not natively support the controller (especially for RAID). You may need to update the controller BIOS or drive firmware, if the mode does not stick. If data corruption occurs verify the cable and consider switching (if any) drives on the same channel onto other channels.
If the built-in controller does not support the mode, consider using the on-board/RAID controller or even disable the built-in controller and install a new controller.
SiSoftware Sandra herjaa kovosta tämmöstä: En ite tajuta tosta mitään...
Warning W3104 - Current transfer mode not optimal, i.e. not highest supported. This affects drive performance. If the controller is also capable of the highest supported transfer mode, there is no reason not to use it.
Fix: First check controller supported transfer modes. Then check the mode the driver for the controller/BIOS is set to use and modify; some default to a lower mode for compatibility. You may need to install newer drivers if the current drivers do not natively support the controller (especially for RAID). You may need to update the controller BIOS or drive firmware, if the mode does not stick. If data corruption occurs verify the cable and consider switching (if any) drives on the same channel onto other channels.
If the built-in controller does not support the mode, consider using the on-board/RAID controller or even disable the built-in controller and install a new controller.
Vastaukset 2
Vanhimmat
että emolevy tukee vain SATA 1:sta, joka selittää tuon suuntaiset herjat. IDE ja SATA levyn liittimet erilaiset, joten niitä ei voi asentaa väärin.
emolevyn pitäisi tukea sata II:sta. Emona on gigabyte GA-965P-DS4.