DOS printit USB printteriin 98:ssa

Dos ei tunne USB:tä ja hädin tuskin W98.kaan.
Jos kirjoittimessa on leveä LPT-liitin niin hankit vain johdon.
Koneestasi LPT löytyy kyllä.

The first step is to install the USB printer normally into Windows. Once the printer is installed and the obligatory test pages print correctly, proceed to the following steps.

Assign the printer a shared name. Generally this happens during installation, but if you skipped that step or somehow installed the printer without giving it a resource name, do that now.

Share names (resource names) should be alphanumeric (the first letter must be an alphabetic character). Even though share names can contain spaces, I recommend not putting spaces in resource names. The reason is because it's more difficult to use operating system commands when spaces exist in the resource name:

net view \\my computer name

If the network administrator for your system insists on names with embedded spaces, here's a way to do it:

net view \\"my computer name"

Next, pick an unused LPT port.
At the operating system prompt, enter the following command:

net use LPT1 \\computer_name\HP /Persistent:Yes

where:

LPT1 is the name of the printer port. Note that a colon (:) does not appear after the port name on the command line.

\\computer_name is the resource name of the computer that is attached to the USB printer.

HP is the resource name of the USB printer assigned in step 1.

/Persistent:Yes denotes that this connection should be reestablished when the system is rebooted.

If the command line above is wrapping to two lines then widen your browser's window because the above command is one command. The above command line can be inserted into the autoexec.bat or network login script, whichever is most appropriate for your installation.


To verify that the connection was successful, use this command:

net view \\computer_name

After the LPT port has been associated with the USB port, open the printer configuration panel:
Start
Settings
Control Panel
Printers
Right Click on the Printer to display its context menu
Choose Properties from the context menu
Change the data stream from RAW to Text mode. Use these steps:
Choose the Advanced tab or button
Choose the Print Processor button
In the Data Type section, change the data type from RAW to TEXT.
Apply and Close the printer panel.


To test that the printer has been successfully configured, at the command prompt, execute:
dir > lpt1:

Small directory listings won't have enough information to force a page to eject, so you might have to repeat this a couple times to get a page to actually print.


Deleting the Connection
To delete the LPT port connection, use the command:

net use LPT1 /Delete