Bluetrek G2 liitos Nokiaan

2. Pairing Bluetrek® G2
Before using the Bluetrek® G2 headset, you must pair it with your Bluetooth® mobile
phone. Pairing is the process of linking 2 Bluetooth® devices, so that they can
communicate.
The pairing only needs to be done once. Afterwards, every time you switch on your
headset, it will automatically connect to your mobile phone. If you pair your
Bluetooth® mobile phone with another Bluetooth® device, you will have to pair the
Bluetrek® G2 with your phone again before use.
The profile (Headset or Hands-Free) is automatically selected by the Mobile phone
during the Pairing stage.
IMPORTANT : Before pairing, all Bluetooth® devices must be switched off.
To initiate the pairing, put both the headset and the mobile phone within 0.3 meter (1
foot) from each other. Make sure there is no Wi-Fi equipment operating in the vicinity.
1. Switch on your phone and select the Bluetooth® discover mode on the Mobile
phone (See the Bluetooth® mobile phone user guide).
PAGE 4 / 4
2. Press and hold (do not release it) the TALK button (see button 1 on page 2) for
about 7 seconds until the indicator light flashes red and blue alternatively. Then
release the TALK Button. A beep can be heard in the speaker.
3.Once the mobile phone detects the headset, a message is displayed with the
following information : “Bluetrek g2”.
4. Follow the phone instructions to accept the pairing. The PIN code (or passkey)
is 0000.
5. When the pairing is completed, the indicator light will switch to blue, and
flashes slowly.
If you haven’t started the discovery mode within 5 minutes, the headset will switch
off. You must then switch on your headset and start the pairing again.
A very limited number of Bluetooth mobile phones require a different pairing
process that the one explained above. If you encounter any difficulties to pair your
headset with your mobile phone, visit our website www.bluetrek.com or consult
your dealer.

ja ohjeen linkki:
http://www.qdcellular.co.za/support/g2/g2usermanual.pdf